equation n. 1.平衡,均衡;平均,相等。 2.【數學】方程式,等式。 3.【天文學】(時)差;均分,等分。 4.【化學】反應式。 algebraic [linear, simple, quadratic, cubic, simultaneous] equation 代數(一次,一元一次,二次,三次,聯立)方程式。 differential equation 微分方程。 an identical equation 恒等式。 equation of light 【天文學】光行時差。 equation of payments 平均分期付款。 equation of state 【物理學】物態方程式。 equation of time 【天文學】時差。 personal equation 【天文學】觀測上的個人誤差。
The control equation for apf power switches was derived , and the steady state model of apf power stage was set up 最后設計、安裝、調試完成一臺500w常頻積分復位器控制的apf實驗樣機。
A new pattern of structures , combined isolation structure , was presented , and its vibration and control equations were derived 摘要提出了一種新的結構體系組合隔震結構體系,并推導了振動及控制方程。
The finite difference discrete is applied on controlling equations after they are converting into the body fitted coordinate system 數值方法上,先將控制方程轉換到貼體坐標系下,然后對其進行有限差分離散。
Based the simplest solutions of control equations , one - cycle controller for the three - phase four - wire apf with four - leg is presented 基于控制方程的最簡解,建立了單周控制四橋臂三相四線制有源電力濾波器的電路模型。
The finite volume method is used to discrete the flow controling equations on staggered grid and the simple algorithm is adopted to solve the equations 采用有限容積法在交錯網格上對流動控制方程離散,然后采用simple算法求解。
In addition , the paper deduces fw pattern distributing rule and motion control equation on the condition of a whole fw cycle 另外,本文還從理論上推導了fw完成一個完整循環的條件下的線型排布規律以及實現其規律的fw線型運動控制方程。
The fdm is applied to the numeric discreteness of control equations under the new coordinates and the corresponding programs are developed 采用有限差分法對新坐標系中的模型控制方程進行了數值離散,根據差分格式編制了相應的計算程序。
The research established the mathematical model and built unitive control equations to outer flow , solid structure and inner flow of the turbine blades 本論文建立了熱?流?固耦合的數學模型,對流體和固體建立了統一的控制方程組,并對方程組的離散。
The heat transfer of the wall and the internal thermal mass is considered in this model . the control equation can be solved by an implicit finite - difference method 利用有限差分方法對該數學模型得到的控制方程組進行離散,并對離散得到的差分方程的計算求解過程進行了編程。
For a impact process with a normal impact velocity , the control equation for rkpm was deduced based on a small strain and incremental elasto - plastic constitutive law 針對沖擊速度較低的情況,假設沖擊過程為小應變,并引入彈塑性增量本構關系,推導出沖擊過程的再生核質點法計算控制方程。